Popular Woodworking 2009-02 № 174, страница 31
PROFILE -13s/8"- ELEVATION — 40V2"- countersink a screw through the front edge at each end into the leg, too. Cut the top to final size, and attach it with buttons at the front and sides. Countersink screws underneath through the back rail into the bottom of the lower section. The Crowning Touches Set up your table saw to cut crown moulding, and sand it smooth before fitting. (For instruction on cutting cove moulding on the table saw, see Senior Editor Glen D. Huey's video under the techniques section at popular woodworking.com/video). Often, the crown is connected with a flat piece to the top edge of the sides and face Cutting crown. The crown is cut by running %" x 4" stock at an angle over the table saw. Raise the blade to /16" then center your stock to the blade. Clamp a long straightedge to the table to guide the stock, then lower the blade and make a series of passes as you gradually raise the blade until you reach 7/16" (or your desired depth). J BACK ELEVATION DETAIL 48 ■ Popular Woodworking February 2009 |
