Woodworker's Journal 101-Projects-for-Woodworkers, страница 80

h

-V

-fii

4

-V

FIG. 5

horizontal frames to match the grooves. Panels are glued up to width and run through the table saw with the blade inclined at 18 degrees. When gluing up the doors, apply glue to the tenoned corner joints, but do not glue the panels; they should be free to contract and expand in their grooves. After the glue has dried, run a %" rabbet around all edges of the doors, then round off the outer edges.

Glue %" stock together to form the countertop.

Carefully cut notches in each end to fit around the cupboard sides and cut a K x rabbet in the back edge for the back panel. Before adding the countertop and its trim, the lower drawer guides and shelf cleats should be installed. The back supporting crossmember is fastened level across the plywood back with screws driven through the plywood. The three drawer supports, which are each made up of two pieces, are then cut, glued, and nailed together so that the upper piece.

73