Woodworker's Journal 2008-32-3, страница 37

TxWxL TxWxL

1 Drawer Case Top (1) 3/4" x 13" x 21%" 15 Top/Middle Drawer Backs (2) 3/4" x 2" x 19"

2 Drawer Case Sides (2) 3/4" x 874" x 13" 16 Bottom Drawer Face (1) 3/4" x 37₂" x 20"

3 Drawer Case Back (1) 3/4" x 8%" x 20Ve" 17 Bottom Drawer Sides (2) 3/4" x 37s" x 12V

4 Drawer Case Bottom (1) 3/4" x 14Va" x 25¹/4" 18 Bottom Drawer Back (1) 3/4" x 3" x 19"

5 Drawer Runners (6) 1/4" x 3/4" x IIV2" 19 Drawer Bottoms (3) 1/4" x 11V x 19"

6 Chest Front (1) 3/4" x 18¹A" x 26" 20 Short Tool Racks (2) 3/4" x 2" x 147₂"

7 Chest Back (1) 3/4" x 187." x 26" 21 Long Tool Rack (1) 3/4" x 2" x 247*"

8 Chest Sides (2) 3/4" x 1874" x 16" 22 Divider Strips (1) 3/8" x 3/4" x Cut to fit

9 Chest Top (1) 3/4" x 1574" x 2574" 23 Drawer Knobs (6) 5/8" Dia. Brass

MATERIAL LIST

Tool Chest Elevation

(Front View)

Top Panel Groove

(Section View)

Use a standard panel-raising bit to form the cove on the top panel.

i Dovetail Y' patterns * vary with specific jigs

Side and Bottom

(Front View)

Bottom

(Top View)

v 7." Dia.

Short Tool i________V-*

Rack i—fv-^

(Top View) 74"

Create holes and slots in the tool racks to fit your specific tools.

Drawer Sides

(Top, End and Side Views)

Rout a 3/16"-deep, 3/4"-wide stopped slot in each drawer side to fit over the drawer runners. ^s/is"*- r*--—127,6"

10 Ball-tip Hinges (2) 27₂" x 1%" Brass 24 Locking Drawbolt (1) 1³A" x 3%" Brass

9 Chest Top (1) 3/4" x 1574" x 2574" 23 Drawer Knobs (6) 5/8" Dia. Brass

10 Ball-tip Hinges (2) 27₂" x 1%" Brass 24 Locking Drawbolt (1) 1³A" x 3%" Brass