Creative Woodworks & crafts 2004-11, страница 59

Fig. 14. To contour, hold a piece in position and draw a pencil line on the edge of the piece it will adjoin.

Fig. 15. Use the pencil line as a guide to contour the higher piece down to the lower one.

Fig. 13. Before cutting the smaller pieces, tape the bottom to a 2" x 4" block with double-sided tape.

down at an angle toward the back, and round over the vertical pieces.

paper on your worktable so the project doesn't become a part of it.

use a 120-grit sanding mop.

Fig. 19. Tilt the saw table about 15° Fig. 20. Use a few C-clamps to

down toward the left and cut the backer ensure a good bond,

approximately 1/0" inside the traced line.

Fig. 21. Finish the project by applying several coats of Krylon matte finish.

Creative Woodworks & Cr afts November 2004 • 59