92, страница 22

92, страница 22

for benchtop

back

(13*x68) BOTTOM Of? (J5V4 X 59)

partition

(lift * 15%)

slide-out

supports

- fit between vertical PARTmONS

top support

top support should slide smoothly without vertical play

Cabinet

workbench

► Sliding Supports. Sturdy bench brackets slide out to level the workbench and make tor a stable worksurface.

build and install the fold-up wor» bench. But first, you need to bu J Hie bench cabinet.

Building the Case. If you look 3 Figure 4 below, you'll see the con st ruction and joinery of the cast' r 1 this cabinet is similar to the open front cabinet on page 20. The or' difference is the addition and loca tion of the vertical dividers for tr* sliding supports (Figure 4a).

After you assemble the case witl glue and screws, just like you d;i before, you can build the two slide out bench supports.

Sliding Supports. The bene supports are pretty simple, a shown in Figure 4. They're piect of MDF cut to fit in the slots create by the partitions in the cabinet, handy finger hole makes it easy t slide them in and out.

With the supports complete, yo can finish out the case by add in the cabinet face frame next.

Face Frame. This face frame is little different than the one on ti storage cabinet you built earlit There are only three pieces to mal

ShopNotes No. i

The benchtop and storage on the previous page is a great addition to any shop. But the centerpiece of this project is the fold-up workbench you see in the mam photo.

To stand up to woodworking tasks, it needs to have a stout support system. This cabinet does the

! FIGURE -------------'-*

woodscrew

TOP<

PILOTHOLES-.^ <,6x-59>

job with its two pullout supports (inset photo above).

You'll start by building the case with its partitions. Then you'll add the sliding supports and top. And you'll need to install another cabinet on the right end to help support the bench cabinet. Later, you'll

* B x FH WOODSCREW

END

(13% x 16)

case bottom fits in groove on back panel

note: all

parts are mdf

slide-out

supports

- fit between vertical PARTmONS

a. f —^

RONT VIEW

*» %

m

<£>

T

®

*

trim TOP edge for snus ftt

Обсуждение
Понравилось?
Войдите чтобы оставить комментарий
Понравилось?